IPA 2 MIXING STATION
![](https://smartsystems-eg.com/wp-content/uploads/IPA_Station_Mischen_UniTrain-h310-ar.jpg)
The IPA mixing station allows a precise mixing of pre-defined formulations. It is the optimum solution for typical production processes in the most varied of industries. The system’s modularity permits diverse configurations to be implemented in a safe laboratory environment.
1 |
![]() |
Course – Process technology: IPA 2 Mixing station | SO4204-3F | |
1 |
![]() |
IPA mixing station | LM9551 | |
1 |
![]() |
Mechatronics aluminium profile carriage without table-top frame | ST7200-3R |
ADDITIONALLY REQUIRED: | ||||
---|---|---|---|---|
1 |
![]() |
25-pin serial interface cable, Sub-D plug/socket | LM9061 |
ADDITIONALLY RECOMMENDED | ||||
---|---|---|---|---|
1 |
![]() |
Compressor, low-noise | SE2902-9L | |
1 |
![]() |
Tubing and accessory set for mechatronics systems | LM9670 | |
In areas where there are high levels of humidity the membrane dryer with water trap should be used to avoid condensation: |
||||
1 |
![]() |
IDG3 membrane dryer with rapid coupling and filter AF20 with water trap | LM9671 |
- Setup, wiring and start-up of a process plant
- Selection, application and connection of various sensors
- Measurement of electrical and process variables such as filling level and flow rate
- Formulation control
- Use and connection of measurement transducers
- Setup and operation of control loops
- Analysis of controlled systems and control loops
- Operation of continuous and discontinuous controllers
- Parameterization and optimization of P-, PI- and PID controllers
- Design of open-loop and closed-loop control programs
- Process handling and monitoring
- Inspection, maintenance and repair
- Networking of process plants