IPA 2 MIXING STATION
The IPA mixing station allows a precise mixing of pre-defined formulations. It is the optimum solution for typical production processes in the most varied of industries. The system’s modularity permits diverse configurations to be implemented in a safe laboratory environment.
| 1 |
 |
Course – Process technology: IPA 2 Mixing station | SO4204-3F | |
| 1 |
 |
IPA mixing station | LM9551 | |
| 1 |
 |
Mechatronics aluminium profile carriage without table-top frame | ST7200-3R | |
| ADDITIONALLY REQUIRED: | ||||
|---|---|---|---|---|
| 1 |
 |
25-pin serial interface cable, Sub-D plug/socket | LM9061 | |
| ADDITIONALLY RECOMMENDED | ||||
|---|---|---|---|---|
| 1 |
 |
Compressor, low-noise | SE2902-9L | |
| 1 |
 |
Tubing and accessory set for mechatronics systems | LM9670 | |
|
In areas where there are high levels of humidity the membrane dryer with water trap should be used to avoid condensation: |
||||
| 1 |
 |
IDG3 membrane dryer with rapid coupling and filter AF20 with water trap | LM9671 | |
- Setup, wiring and start-up of a process plant
- Selection, application and connection of various sensors
- Measurement of electrical and process variables such as filling level and flow rate
- Formulation control
- Use and connection of measurement transducers
- Setup and operation of control loops
- Analysis of controlled systems and control loops
- Operation of continuous and discontinuous controllers
- Parameterization and optimization of P-, PI- and PID controllers
- Design of open-loop and closed-loop control programs
- Process handling and monitoring
- Inspection, maintenance and repair
- Networking of process plants
